Use these procedures to troubleshoot the LIN communication system.
*: Use the Techstream.
| Result |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Result |
|---|
| NEXT |
NEXT
Using the Techstream, inspect the CAN communication function to ensure there are no malfunctions in the communication system.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| DTCs output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Using the Techstream, inspect the LIN communication function to ensure there are no malfunctions in the communication system.
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| DTCs output | B |
A
B
Data List/Active Test
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT