Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › from 2016.10
RM27L0U _59 Vehicle Exterior _049355 EXTERIOR PANELS / TRIM _0236010 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK

If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.


PROCEDURE

Hide 76626E 1.REMOVE REAR QUARTER PANEL MUDGUARD LH

B191653

a.

Remove the 9 screws.


b.

Remove the clip and rear quarter panel mudguard.


Hide 76625G 2.REMOVE REAR QUARTER PANEL MUDGUARD RH

HINT:

Use the same procedure as for the LH side.


Hide 52159 3.REMOVE REAR BUMPER COVER

B191654E02
0.917,1.323 0.823,1.74 false 0.344,1.75 1.375,1.99 1.031,0.24 10 true Protective Tape

a.

Apply protective tape as shown in the illustration.


b.
B191655

Remove the 8 bolts, 2 screws and 2 clips.


c.
B195443

Disengage the 2 harness clamps and disconnect the connector.


d.
B191656

Disengage the 12 claws and remove the rear bumper cover.