Home › DRIVE LINE › DRIVE SHAFT › REAR DRIVE SHAFT (for 4WD)

REAR DRIVE SHAFT (for 4WD) > INSTALLATION

for Preparation Click here



1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH


    C097746E01
  1. Install the drive shaft to the axle carrier.

    NOTICE:
    Be careful not to damage the boot and ABS speed sensor rotor to the drive shaft and oil seal of the axle hub bearing.

  1. Align the matchmarks and connect the drive shaft to the side gear shaft.

    NOTICE:
    Be careful not to damage the boots and end cover.

  1. Install the drive shaft with the 4 nuts and washers.

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }



2. INSTALL REAR AXLE SHAFT NUT
  1. Clean the threaded parts on the drive shaft and rear axle shaft nut using a non-residue solvent.

    NOTICE:
    1. Be sure to perform this work for a new drive shaft.
    2. Keep the threaded parts free of oil and foreign objects.



    C089301
  1. Install a new axle shaft nut.

    Torque:
    216 N*m{ 2,200 kgf*cm , 159 ft.*lbf }

  1. Using a chisel and hammer, stake the axle shaft nut.



3. INSTALL TAIL EXHAUST PIPE ASSEMBLY
  1. Install a new gasket to the center exhaust pipe assembly.

  1. Connect the 4 exhaust pipe supports, and install the tail exhaust pipe assembly.



  1. Install 2 new bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



    A162161



4. INSTALL REAR SPEED SENSOR
  1. Install the speed sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    HINT:
    1. Be careful not to damage the speed sensor.
    2. Prevent foreign matter from adhering to the speed sensor.
    3. Do not twist the sensor wire when installing the sensor.



5. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



6. CHECK FOR EXHAUST GAS LEAK


7. CHECK ABS SPEED SENSOR SIGNAL

HINT:
  1. for ANTI-LOCK BRAKE SYSTEM: (Click here)
  2. for VEHICLE STABILITY CONTROL SYSTEM: (Click here)