Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SEAT POSITION SENSOR

SEAT POSITION SENSOR > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

HINT:
(Click here)



4. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

HINT:
(Click here)



5. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)

HINT:



6. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat)

HINT:



7. REMOVE VERTICAL ADJUSTING HANDLE NO.2 (for Manual Seat)


8. REMOVE FRONT SEAT CUSHION SHIELD LH (for Manual Seat)

HINT:



9. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for Power Seat)

HINT:



10. REMOVE RECLINING POWER SEAT SWITCH KNOB (for Power Seat)

HINT:



11. REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY
  1. Remove the 5 screws and the front seat cushion shield assembly.



12. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR


    C108775E01
  1. Remove the seat slide position sensor protector from the seat position sensor.



13. REMOVE SEAT POSITION SENSOR
  1. Disconnect the connector from the seat position sensor.



    H045347E01
  1. Using a "torx" socket wrench (T30), remove the "torx" screw and the seat position sensor.