Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the cruise control main switch is on, the CRUISE main indicator light and READY indicator light come on. This indicates the control condition (presence or absence of a vehicle in front, vehicle-to-vehicle distance, and set vehicle speed) and fail-safe state through the multiplex communication system. The master warning light and CRUISE main indicator light come on and vehicle-to-vehicle distance information is displayed on the combination meter as the alarm buzzer sounds.

HINT:
If the vehicle in front in the same lane significantly decreases vehicle speed or another vehicle cuts in front of your vehicle, adequate deceleration cannot be applied and the vehicle-to-vehicle distance will shorten. At this time, the system sounds the buzzer and the multi-information display blinks to warn the driver.


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the CRUISE main indicator light by performing the Active Test.

    Combination Meter: 
    Techstream Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    Cruise main indicator light
    BLINK / OFF
    -



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK


2.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Laser Cruise / Data List.

  1. Check the Data List for proper functioning of the CRUISE main indicator light.

    ECM (Laser Cruise): 
    Techstream Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Ready M-CPU
    Cruise control system standby condition (Main CPU) / ON or OFF
    Each time main switch is pushed, ON / OFF changes
    "1"
    CCS Indicator M-CPU
    Cruise indicator signal (Main CPU) / ON or OFF
    ON: "CRUISE" ON
    OFF: "CRUISE" OFF
    "2"

    OK:
    When the cruise control main switch is operated, the display changes as shown above.

    HINT:
    "1" is OK, but "2" is NG → DTC output or ECM failure



NG
REPLACE ECM (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)