Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > Wiper Signal Circuit

for Preparation Click here


DESCRIPTION

The distance control ECU detects wiper operation. If the windshield wipers operate in the HI or LO mode, the cruise control is canceled and the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:
  1. The CRUISE main indicator light blinks.
  2. The master warning light illuminates.
  3. The warning code "E2" is displayed on the display in the combination meter.
After HI or LO wiper operation stops, pushing the cruise control main switch to + (ACCEL)/RES (RESUME) will resume the vehicle speed set prior to cancellation.
Cruise control is available when the windshield wipers operate in the intermittent mode.

WIRING DIAGRAM


E144488E01


INSPECTION PROCEDURE

1.INSPECT WIPER SYSTEM
Check that the windshield wipers operate in HI mode.

OK:
Wiper function is normal.



NG
GO TO WIPER AND WASHER SYSTEM (Front wipers do not operate in LO or HI.) (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - WINDSHIELD WIPER SWITCH)


    E141659E01
  1. Disconnect the distance control ECU connector and windshield wiper switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D2-2 (WIP2) - C12-8 (+2)
    Always
    Below 1 Ω
    C12-8 (+2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)