Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > VSC Warning Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN and multiplex communications.
If the skid control ECU stores DTCs to shut down TRAC and VSC operation, the VSC warning light comes on in the combination meter.

WIRING DIAGRAM

Refer to VSC Warning Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if the CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    CAN communication system DTC is not output
    A
    CAN communication system DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM
A


2.CHECK MULTIPLEX COMMUNICATION SYSTEM
  1. Check if the multiplex communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    Multiplex communication system DTC is not output
    A
    Multiplex communication system DTC is output
    B



B
INSPECT MULTIPLEX COMMUNICATION SYSTEM
A


3.CHECK VSC WARNING LIGHT
  1. Connect Techstream to the DLC3.

  1. Start the engine.

  1. Select the Active Test mode on Techstream (Click here).

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    VSC Warning Light
    VSC warning light
    Warning light ON / OFF
    Observe combination meter

  1. Check that "ON" and "OFF" of the VSC warning light are indicated on the combination meter when using Techstream.

    OK:
    The VSC warning light turns on or off in accordance with Techstream.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
Go to step 4
OK

REPLACE BRAKE ACTUATOR ASSEMBLY 

4.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Check the combination meter (Click here).

    OK:
    The combination meter is normal.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY
OK

REPLACE BRAKE ACTUATOR ASSEMBLY