Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here



Vehicle Stability Control System: 
Symptom
Suspected Area
See page
ABS, BA and EBD do not operate
1. Check the DTC again and make sure that the normal code is output.
Click here
2. IG power source circuit and ground circuit.
Click here
3. Speed sensor circuit (Front)
Click here
4. Speed sensor circuit (Rear)
Click here
5. Check the brake actuator assembly with Techstream.
Click here
6. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the brake actuator assembly (skid control ECU).
Click here
ABS, BA and EBD do not operate efficiently
1. Check the DTC again and make sure that the normal code is output.
Click here
2. Speed sensor circuit (Front)
Click here
3. Speed sensor circuit (Rear)
Click here
4. Stop light switch circuit
Click here
5. Check the brake actuator assembly with Techstream.
Click here
6. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the brake actuator assembly (skid control ECU).
Click here
ABS warning light abnormal (Remains on)
1. ABS warning light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
ABS warning light abnormal (Does not come on)
1. ABS warning light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
BRAKE warning light abnormal
1. BRAKE warning light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
DTC of ABS check cannot be done
1. Check the DTC again and make sure that the normal code is output.
Click here
2. TC and CG terminal circuit
Click here
3. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the brake actuator assembly (skid control ECU).
Click here
Sensor signal check cannot be done
1. TS and CG terminal circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
VSC and/or TRAC does not operate
1. Check the DTC again and make sure that the normal code is output.
Click here
2. IG power source circuit and ground circuit.
Click here
3. Check the hydraulic circuit for leakage.
-
4. Speed sensor circuit (Front)
Click here
5. Speed sensor circuit (Rear)
Click here
6. Yaw rate and deceleration sensor circuit (Zero point calibration malfunction)
Click here
7. Yaw rate and deceleration sensor circuit (Sensor malfunction)
Click here
8. Steering angle sensor circuit (Zero point calibration malfunction)
Click here
9. Steering angle sensor circuit (Sensor malfunction)
Click here
10. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the brake actuator assembly (skid control ECU).
Click here
SLIP indicator light abnormal (Remains on)
1. SLIP indicator light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
SLIP indicator light abnormal (Does not come on)
1. SLIP indicator light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
TRAC OFF indicator light abnormal (Remains on)
1. TRAC OFF indicator light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
TRAC OFF indicator light abnormal (Does not come on)
1. TRAC OFF indicator light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
DTC of VSC check cannot be done
1. Check the DTC again and make sure that the normal code is output.
Click here
2. TC and CG terminal circuit
Click here
3. If the symptoms still occur even after the above circuits in suspected areas are inspected and proved to be normal, replace the brake actuator assembly (skid control ECU).
Click here
VSC warning light abnormal (Remains on)
1. VSC warning light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here
VSC warning light abnormal (Does not come on)
1. VSC warning light circuit
Click here
2. Brake actuator assembly (Skid control ECU)
Click here