Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P1570    Radar Sensor Malfunction

for Preparation Click here


DESCRIPTION

The laser sensor emits laser beams towards an object in front and measures the distance and direction of the object by receiving the beam reflections. Based on the reflections, the sensor calculates the difference in speed between your own vehicle and an object in front. This data is transmitted to the distance control ECU.

DTC No.
DTC Detection Condition
Trouble Area
P1570
The ECM detects a laser sensor malfunction signal for 0.15 seconds or more while the dynamic laser cruise control is in operation
Laser sensor

HINT:
The laser sensor monitors the laser emission and reception by itself. This DTC is detected when it cannot monitor. When rain drops or snowflakes strike the laser sensor face, the distance between the vehicle in front and your own vehicle cannot be measured correctly. The dynamic laser cruise control system functions by detecting the reflector of the vehicle directly in front. In the following cases, the system may not be able to detect the vehicle in front and may not properly maintain the correct vehicle-to-vehicle distance:
  1. The vehicle in front is a tall trailer.
  2. The back of the vehicle in front is extremely dirty.
  3. Emission from the vehicle in front or vehicles in other lanes is heavy.
  4. The vehicle in front has no reflector.
  5. The laser sensor is receiving a strong flash of light (sunlight, etc.)


INSPECTION PROCEDURE

NOTICE:
When the laser sensor is replaced with a new one, adjustment of the laser sensor beam axis must be performed (Click here).

1.ADJUST LASER SENSOR
Refer to adjustment (Click here).

HINT:
It is necessary to make the ECM recognize specification information (whether the vehicle is equipped with the dynamic laser cruise control system or not). When this procedure has not been carried out, this DTC may be output.

  1. Clear the DTCs and then recheck for DTCs.

    OK:
    DTC is not output.



NG
REPLACE LASER SENSOR (Click here)
OK

SYSTEM IS OK