Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P1572    Improper Aiming of Radar Sensor Beam Axis

for Preparation Click here


DESCRIPTION

This DTC is output when the scanning angle of the laser sensor is incorrect. This DTC is also output when the laser sensor beam axis is determined to be in an incorrect position.

DTC No.
DTC Detection Condition
Trouble Area
P1572
The ECU detects that the laser sensor beam axis is in an incorrect position (0.15 seconds or more) while the dynamic laser cruise control is in operation
Laser sensor

INSPECTION PROCEDURE

NOTICE:
When the laser sensor is replaced with a new one, adjustment of the laser sensor beam axis must be performed (Click here).

1.ADJUST LASER SENSOR
Refer to adjustment (Click here).

HINT:
It is necessary to make the ECM recognize specification information (whether the vehicle is equipped with the dynamic laser cruise control system or not). When this procedure has not been carried out, this DTC may be output.

  1. Clear the DTCs and then recheck for DTCs.

    OK:
    DTC is not output.



NG
REPLACE LASER SENSOR (Click here)
OK

SYSTEM IS OK