Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING


HINT:
  1. Use this procedure to troubleshoot the theft deterrent system.
  2. Techstream should be used in step 2.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here)


    NEXT


    3.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)
    1. Use Techstream to check for normal function of the multiplex communication system.

      1. (ECU unconnected, communication line malfunctioning) Without code output, proceed to A.

      2. (ECU unconnected, communication line malfunctioning) With code output, proceed to B.



    B.
    Go To MULTIPLEX COMMUNICATION SECTION
    A


    4.SYMPTOM SIMULATION

      NEXT


      5.PROBLEM SYMPTOMS TABLE
      1. If the fault is not listed on the problem symptoms table, proceed to A.

      2. If the fault is listed on the problem symptoms table, proceed to B.



      B.
      Go to step 7
      A


      6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
      1. Terminals of ECU (Click here)

      2. System description (Click here)



      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.CONFIRMATION TEST

          NEXT

          END