Home › DRIVE LINE › MF2A TRANSFER › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE ENGINE AND TRANSAXLE

HINT:
(Click here)



2. REMOVE AUTOMATIC TRANSMISSION WITH TRANSFER

HINT:
(Click here)



3. REMOVE NO. 1 TRANSFER CASE PLUG


    C082977E01
  1. Remove the No. 1 transfer case plug.

  1. Remove the No. 1 gasket from the transfer case No. 1 plug.



4. REMOVE NO. 2 TRANSFER CASE PLUG
  1. Remove the No. 2 transfer case plug.

  1. Remove the No. 2 gasket from the No. 2 transfer case plug.



5. REMOVE TRANSFER DRAIN PLUG
  1. Remove the transfer drain plug and bleed the oil.

  1. Remove the drain gasket from the transfer drain plug.



6. REMOVE TRANSFER ASSEMBLY


    C082785E01
  1. Remove the 2 bolts and 6 bolts.

  1. Using a plastic hammer, remove the transfer assembly from the transaxle assembly.

    NOTICE:
    1. Remove the transfer assembly from the transaxle assembly without tilting it.
    2. When removing the transfer assembly, do not hold onto the oil seal parts on both sides of the assembly.