OCCUPANT CLASSIFICATION ECU > INSTALLATION |
| 1. INSTALL OCCUPANT CLASSIFICATION ECU |
Check that the ignition switch is off.
Check that the negative battery (-) terminal is disconnected.
![]() |
Install the occupant classification ECU.
Connect the 2 connectors to the occupant classification ECU.
| 2. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) |
| 3. INSTALL FRONT RH SEAT ASSEMBLY (for Power Seat) |
| 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 5. PERFORM INITIALIZATION |
Perform initialization.
| 6. INSPECT SLIDE ADJUSTER LOCK (for Manual Seat) |
| 7. INSPECT POWER SEAT OPERATION (for Power Seat) |
| 8. INSPECT SEAT HEATER OPERATION (w/ Seat Heater System) |
| 9. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).