Home › DRIVE LINE › DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY

REAR DIFFERENTIAL CARRIER ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE EXHAUST PIPE ASSEMBLY

HINT:
(Click here)



3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

HINT:
(Click here)



4. REMOVE REAR DIFFERENTIAL FILLER PLUG
  1. Using a hexagon wrench (10 mm), remove the filler plug and gasket.



5. REMOVE REAR DIFFERENTIAL DRAIN PLUG
  1. Using a hexagon wrench (10 mm), remove the drain plug and gasket, and drain the oil.



6. REMOVE REAR SPEED SENSOR LH

HINT:
Removal procedure or RH side is the same as that or LH side. (Click here)



7. REMOVE REAR AXLE SHAFT NUT LH

HINT:
Removal procedure or RH side is the same as that or LH side. (Click here)



8. REMOVE REAR DRIVE SHAFT ASSEMBLY LH

HINT:
Removal procedure or RH side is the same as that or LH side. (Click here)



9. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
  1. Support the rear differential carrier assembly with a jack.



    D030574
  1. Remove the bolt and nut, separate the No. 1 rear differential support.



    D030575
  1. Remove the 2 bolts, separate the rear differential support assembly.

    NOTICE:
    Be careful not to drop the rear differential carrier assembly.



10. REMOVE REAR DIFFERENTIAL SUPPORT ASSEMBLY


    D030577
  1. Remove the 3 bolts and rear differential support assembly.



11. REMOVE REAR DIFFERENTIAL DYNAMIC DAMPER


    D030576
  1. Remove the 2 bolts and rear differential dynamic damper from the No. 1 rear differential support.



12. REMOVE NO. 1 REAR DIFFERENTIAL SUPPORT


    C097682
  1. Remove the 2 bolts, 2 nuts and No. 1 rear differential support.