Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the engine immobiliser system.
  2. Techstream should be used in steps 4, 5 and 7.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.CRANK ENGINE FOR MORE THAN 10 SECONDS

        NEXT


        4.CHECK FOR DTC
        1. Check for DTCs and note any codes that are output.

        2. Delete the DTC.

        3. Recheck for DTCs. Try to prompt the DTC (SFI system and engine immobiliser system) by simulating the original activity that the DTC suggested.

          1. If the DTC does not reoccur, proceed to A.

          2. If the DTC (SFI system) reoccurs, proceed to B.

          3. If the DTC (engine immobiliser system) reoccurs, proceed to C.



        B.
        Go to SFI SYSTEM

        C.
        Go to step 8
        A


        5.READ VALUE OF TECHSTREAM ((IMMOBILISER ECU (TRANSPONDER KEY ECU ASSEMBLY) (SWITCH CONDITION))
        1. Connect Techstream to the DLC3.

        2. Turn the ignition switch on.

        3. Turn the tester on.

        4. Select the following menu items: Body Electrical / Immobiliser / Data List.

        5. Read the Data List according to the display on the tester.

          Immobiliser 
          Tester Display
          Measurement Item/Range
          Normal Condition
          Diagnostic Note
          KEY SW
          Unlock warning switch signal / ON or OFF
          ON: Key is in ignition key cylinder
          OFF: No key is in ignition key cylinder
          -



        NG.
        Go to DTC B2780
        OK


        6.PROBLEM SYMPTOMS TABLE
        1. If the fault is not listed on the problem symptoms table, proceed to A.

        2. If the fault is listed on the problem symptoms table, proceed to B.



        B.
        Go to step 8
        A


        7.OVERALL ANALYSIS AND TROUBLESHOOTING
        1. DATA LIST / ACTIVE TEST (Click here)

        2. Terminals of ECU (Click here).


        NEXT


        8.ADJUST, REPAIR OR REPLACE

          NEXT


          9.CONFIRMATION TEST

            NEXT

            END