Home › BRAKE › PARKING BRAKE › PARKING BRAKE PEDAL

PARKING BRAKE PEDAL > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL


2. REMOVE FRONT DOOR SCUFF PLATE LH


3. REMOVE COWL SIDE TRIM BOARD LH


4. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER LH


    B066070E01
  1. Remove the 2 bolts <A>.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the 2 claws and 3 clips, and then remove the instrument panel finish panel sub-assembly lower LH.

  1. Disconnect the connectors.



5. REMOVE REAR DOOR SCUFF PLATE RH


6. REMOVE REAR DOOR SCUFF PLATE LH


7. REMOVE FRONT SEAT ASSEMBLY LH

HINT:
  1. Manual Seat Type (Click here)
  2. Power Seat Type (Click here)
  3. Fold Flat Type (Click here)



8. REMOVE REAR SEAT NO.1 ASSEMBLY

HINT:
  1. Captain Seat Type (Click here)
  2. Center Seat Type (Click here)



9. REMOVE REAR FLOOR SEAT LOCK COVER


10. REMOVE REAR FLOOR SEAT LOCK COVER


11. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY


    F045025
  1. Remove the 4 nuts and separate the instrument panel junction block assembly w/ wiring harness connector from the body.

  1. Disconnect the parking brake switch connector.

  1. Remove the bolt, 2 nuts and parking brake control pedal assembly.