Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    U1102    Lost Communication with Radar Sensor

for Preparation Click here


DESCRIPTION

The laser sensor and distance control ECU transmit the data for general vehicle control and diagnosis function along the communication line. The distance control ECU determines the curve radius information based on signals from the steering wheel and yaw rate sensor. The distance control ECU transmits the current vehicle speed and curve radius information to the laser sensor.

DTC No.
DTC Detection Condition
Trouble Area
U1102
The ECM detects a communication error signal (from the distance control ECU to the laser sensor) for 0.15 seconds or more while the dynamic laser cruise control is in operation
  1. Communication circuit
  2. Laser sensor
  3. Distance control ECU

WIRING DIAGRAM


E134921E03


INSPECTION PROCEDURE

NOTICE:
  1. When the distance control ECU is replaced with a new one, initialization must be performed .
  2. When the laser sensor is replaced with a new one, adjustment of the laser sensor beam axis must be performed (Click here).

1.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - LASER SENSOR)


    E135385E06
  1. Disconnect the distance control ECU connector and laser sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D2-23 (LRRD) - L1-4 (LRRD)
    Always
    Below 1 Ω
    D2-13 (IGB) - L1-5 (IGB)
    Always
    Below 1 Ω
    D2-23 (LRRD) - Body ground
    Always
    10 kΩ or higher
    D2-13 (IGB) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK DISTANCE CONTROL ECU
  1. Reconnect the distance control ECU connector.



    E135386E08
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D2-13 (IGB) - Body ground
    Ignition switch ON
    10 to 14 V

  1. Reconnect the laser sensor connector.



NG
REPLACE DISTANCE CONTROL ECU (Click here)
OK


3.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON.

  1. Check if the same DTC is recorded (Click here).

    Result:

    Result
    Proceed to
    DTC U0235 is not output
    A
    DTC U0235 is output
    B



B
REPLACE LASER SENSOR (Click here)
A

END (INTERMITTENT PROBLEM IS PRESENT)