Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > CAN Bus Line

for Preparation Click here


DESCRIPTION

When any DTC for the CAN communication system is output, first measure the resistance between the terminals of the DLC3 to specify the trouble area, and check that there is no short in the CAN main wire, between the main wire, and +B or GND.

WIRING DIAGRAM


C161419E01


C161420E01


INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches, or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the ignition switch, any switches, or any doors triggers related ECU and sensor communication with the CAN. This communication will cause the resistance value to change.

1.CHECK CAN BUS WIRE (MAIN WIRE FOR DISCONNECTION, CAN BUS LINES FOR SHORT CIRCUIT)


    C126231E23
  1. Turn the ignition switch off.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Result
    Proceed to
    D1-6 (CANH) - D1-14 (CANL)
    Ignition switch off
    54 to 69 Ω
    A
    D1-6 (CANH) - D1-14 (CANL)
    Ignition switch off
    69 Ω or higher
    B
    D1-6 (CANH) - D1-14 (CANL)
    Ignition switch off
    Below 54 Ω
    C



B
CHECK OPEN IN CAN MAIN BUS LINE (Click here)

C
CHECK CAN BUS LINES FOR SHORT CIRCUIT (Click here)
A


2.CHECK FOR SHORT TO B+ IN CAN BUS WIRE


    C118856E51
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D1-6 (CANH) - D1-16 (BAT)
    Ignition switch off
    6 kΩ or higher
    D1-14 (CANL) - D1-16 (BAT)
    Ignition switch off
    6 kΩ or higher



NG
CHECK CAN BUS LINE FOR SHORT TO +B (Click here)
OK


3.CHECK FOR SHORT TO GND IN CAN BUS WIRE


    C118856E52
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D1-6 (CANH) - D1-4 (CG)
    Ignition switch off
    200 Ω or higher
    D1-14 (CANL) - D1-4 (CG)
    Ignition switch off
    200 Ω or higher



NG
CHECK CAN BUS LINE FOR SHORT TO GND (Click here)
OK

GO TO HOW TO PROCEED WITH TROUBLESHOOTING (Click here)