Home › BODY › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM

BACK DOOR CLOSER SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Troubleshoot in accordance with the procedures on the following pages.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK

      NEXT


      3.INSPECT COMMUNICATION FUNCTION OF LARGE-SCALE MULTIPLEX COMMUNICATION SYSTEM (BEAN)
      1. Use the Techstream to check for normal function of the multiplex communication system.

        1. (ECU unconnected, communication line malfunctioning) Without code outputs, proceed to A.

        2. (ECU unconnected, communication line malfunctioning) With code outputs, proceed to B.



      B.
      Go to MULTIPLEX COMMUNICATION SECTION
      A


      4.DTC CHECK
      1. Check for a DTCs.

        1. Without code outputs, proceed to A.

        2. With code outputs, proceed to B.



      B.
      Go to step 6
      A


      5.PROBLEM SYMPTOMS TABLE
      1. When problem is not listed on problem symptoms table, proceed to A.

      2. When problem is listed on problem symptoms table, proceed to B.



      B.
      Go to step 7
      A


      6.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM
      1. Data List / Active Test (Click here).

      2. Inspection.

      3. Terminals of ECU (Click here).


      NEXT


      7.ADJUST, REPAIR OR REPLACE

        NEXT


        8.RESET BACK DOOR SYSTEM

          NEXT


          9.CONFIRMATION TEST

            NEXT

            END