Home › BODY › MIRROR › POWER MIRROR CONTROL SYSTEM (w/ Memory)

POWER MIRROR CONTROL SYSTEM (w/ Memory) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the power door lock control system.
  2. Techstream should be used in steps 4 and 5.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in the problem analysis:

        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Running conditions, driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V
      If the voltage is below 11 V, recharge or replace the battery before proceeding.


    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)
    1. Use Techstream to check if the Multiplex Communication System (MPX) is functioning normally (Click here).

      Result:
      Result
      Proceed to
      MPX DTC is not output
      A
      MPX DTC is output
      B



    B.
    Go to MULTIPLEX COMMUNICATION SYSTEM
    A


    5.PROBLEM SYMPTOMS TABLE

      Result:

      Result
      Proceed to
      Fault is not listed on problem symptoms table
      A
      Fault is listed on problem symptoms table
      B



    B.
    After repair, go to step 8
    A


    6.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU
      (Click here)

    2. DATA LIST/ACTIVE TEST
      (Click here)


    NEXT


    7.REPAIR OR REPLACE

      NEXT


      8.CONFIRMATION TEST

        NEXT

        END