Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING (for 2WD)

REAR AXLE HUB AND BEARING (for 2WD) > INSTALLATION

for Preparation Click here



1. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH


    C066210E05
  1. Install the hub & bearing assembly LH with new 4 nuts.

    Torque:
    67 N*m{ 683 kgf*cm , 49 ft.*lbf }



2. INSPECT BEARING BACKLASH


    C083015E03
  1. Using a dial gauge, check for backlash near the center of the axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    If backlash exceeds the maximum, replace the axle hub assembly.

    NOTICE:
    Ensure that the dial gauge is set at right angles to the measurement surface.



3. INSPECT AXLE HUB DEVIATION


    C083016E03
  1. Using a dial gauge, check for deviation in the surface of the axle hub outside the hub bolt.

    Maximum:
    0.07 mm (0.0027 in.)

    If backlash exceeds the maximum, replace the axle hub assembly.

    NOTICE:
    Ensure that the dial gauge is set at right angles to the measurement surface.



4. CONNECT SKID CONTROL SENSOR WIRE
  1. Connect the connector.

    NOTICE:
    Do not twist the sensor wire when connecting it.



5. INSTALL REAR DISC
  1. Install the rear disc for disc rear brake type.



6. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
  1. Install the rear brake drum sub-assembly for drum rear brake type.



7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Install the rear disc brake caliper assembly LH with the 2 bolts for disc rear brake type.

    Torque:
    88 N*m{ 900 kgf*cm , 65 ft.*lbf }



8. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }



9. CHECK ABS SPEED SENSOR SIGNAL
  1. ABS WITH EBD SYSTEM (Click here).

  1. ABS WITH EBD & BA & TRAC & VSC SYSTEM (Click here).