REAR CENTER SEAT OUTER BELT ASSEMBLY > INSTALLATION |
| 1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY |
![]() |
Check the degree of tilt when the belt begins to lock the ELR.
Check that the belt does not lock within 15° of tilt in all directions but that the belt locks with over 45° of tilt, when gently moving the retractor.
If operation is not as specified, replace the 3 point type No. 2 rear seat belt assembly.
Install the 3 point type No. 2 rear seat belt assembly with the 2 bolts and 2 nuts.
Check the ELR lock.
Check that the belt locks when pulling out the belt quickly when the belt is installed.
If operation is not as specified, replace the 3 point type No. 2 rear seat belt assembly.
Check the fastening function of the child restraint system.
Check that the belt cannot be pulled out any more but can be rewound after the belt is fully pulled out.
Check that the belt can be pulled out and rewound after the belt is fully rewound.
If operation is not as specified, replace the 3 point type No. 2 rear seat belt assembly.
Install the roof headlining.
| 2. INSTALL NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger) |
![]() |
Check the degree of tilt when the belt begins to lock the ELR.
Check that the belt does not lock within 15° of tilt in all directions but that the belt locks with over 45° of tilt, when gently moving the retractor.
If operation is not as specified, replace the No. 1 rear seat outer belt assembly.
Install the No. 1 rear seat outer belt assembly with the 2 bolts and 3 nuts.
Check the ELR lock.
Check that the belt locks when pulling out the belt quickly when the belt is installed.
Check the fastening function of the child restraint system.
Check that the belt cannot be pulled out any more but can be rewound after it is fully pulled out.
Check that the belt can be pulled out and rewound after the belt is fully rewound.
If operation is not as specified, replace the No. 1 rear seat outer belt assembly.
Install the rear seat shoulder belt cover.
Install the rear seatback board.