Home › ENGINE › 2GR-FE ENGINE MECHANICAL › ENGINE REAR OIL SEAL

ENGINE REAR OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE REAR OIL SEAL


    A132245E01
  1. Apply MP grease to a new oil seal lip.

  1. Using SST and a hammer, tap in the oil seal.

    SST
    09223-15030  
    09950-70010   (09951-07150)

    Oil seal tap in depth:
    -0.5 to 0.5 mm (-0.020 to 0.020 in.)



2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A129631E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011   (09213-70020)
    09330-00021  



    P000601E04
  1. Apply adhesive to 2 or 3 threads of the mounting bolt end.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent




      A132243E01
    1. Install the front spacer, drive plate and rear spacer on the crankshaft.

    2. Install and tighten the 8 mounting bolts uniformly in several steps.

      Torque:
      83 N*m{ 850 kgf*cm , 61 ft.*lbf }



3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)

HINT:
Click here.



4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for 4WD)

HINT:
Click here.