Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > Washer Signal Circuit

for Preparation Click here


DESCRIPTION

The distance control ECU detects washer operation. The cruise control will be cancelled by the distance control ECU if the windshield wipers operate in the HI or LO mode. By detecting washer operation, the distance control ECU allows the cruise control to continue even when the windshield wipers operate in the HI or LO mode.

WIRING DIAGRAM


E144488E02


INSPECTION PROCEDURE

1.INSPECT WASHER SYSTEM
  1. Check that the front washer operates.

    OK:
    Washer function is normal.



NG
GO TO WIPER AND WASHER SYSTEM (Front washer motor does not operate.) (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - WINDSHIELD WIPER SWITCH)


    E141659E02
  1. Disconnect the distance control ECU connector and windshield wiper switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D2-3 (WASH) - C12-11 (WF)
    Always
    Below 1 Ω
    C12-11 (WF) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)