Home › General › MAINTENANCE › FRONT DISC BRAKE PAD (except 4-Pot Caliper)
RM3650E _V1 General _079881 MAINTENANCE _0387546 FRONT DISC BRAKE PAD(except 4-Pot Caliper) A

MAINTENANCE  FRONT DISC BRAKE PAD(except 4-Pot Caliper)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT DISC BRAKE PAD

a.
C413321

Clean the contact surface (1) of the front disc brake piston with brake cleaner and apply a thin coat of brake pad paste.


b.

Check the cylinder boot for damage and replace if necessary.


c.
C413322

Clean the contact surface of the front disc brake cylinder assembly with brake cleaner and apply a thin coat of brake pad paste.


d.
C413320

Clean the contact surface (1) of the front disc brake cylinder mounting with brake cleaner and apply a thin coat of brake pad paste.

NOTICE:

Do not mechanically clean the contact surfaces (1) for the front disc brake pads at the front disc brake cylinder mounting to prevent damage to the surface coating.



e.
C413324

Lightly coat the T-head of the outer front disc brake pad with brake pad paste in this area.


f.
C413323

Coat the T-head of outer front disc brake pad in the marked area (1) in each case with a thin coating of brake pad paste.


g.
C413325

Install the front disc brake pads (1) in the direction of the arrow.


h.

Remove the rope.


i.

Install the front disc brake cylinder assembly.


j.

Replace bolts.


k.

Tighten the bolts, if applicable, hold against the hexagon head.

Torque:
35 N*m (357 kgf*cm, 26 ft.*lbf)


Hide 2.INSTALL PAD WEAR INDICATOR WIRE LH (for LH Side)

a.
C413316

Replace the pad wear indicator wire LH (1).


b.

Insert the pad wear indicator wire LH (1) into the front disc brake pad in the direction of the arrow.


c.

Ensure pad wear indicator wire LH fits correctly in front disc brake pad.


d.

Attach cable of pad wear indicator wire LH in brackets.


e.

Connect connectors and lock.


f.

Close the connection box.


Hide 3.INSTALL FRONT WHEEL

Hide 4.INSPECT FRONT BRAKE

NOTICE:
·

When exchanging brake pads, reset the CBS display in accordance with factory specification (CBS reset).

·

Carry out test braking while driving at low speed because the effectiveness of the brakes may be reduced during the initial braking operations.

·

Exaggerated emergency and continuous braking operations for faster bedding-in are not permitted.

·

Advise the customer not to perform intentional emergency braking operations for the first 200 km (124 mile) after the brakes have been replaced.



a.

Fully depress brake pedal several times so that brake pads contact brake discs.


b.

Adjust the brake fluid level to the maximum mark.


c.

Perform a functional check on the brake test stand to ensure compliance of the brake system with statutory guidelines.