Home › General › MAINTENANCE › FRONT DISC BRAKE PAD (for 4-Pot Caliper)
RM3650E _V1 General _079881 MAINTENANCE _0387547 FRONT DISC BRAKE PAD(for 4-Pot Caliper) A

MAINTENANCE  FRONT DISC BRAKE PAD(for 4-Pot Caliper)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT DISC BRAKE PAD

NOTICE:
·

After the brake pads have been installed, the brake pads must immediately be bonded to the brake pistons:

-

Press the brake pedal to the floor and hold the pressure for 1 minute. This causes the front disc brake pads to adhere to the front disc brake pistons.




a.
C413329

Clean the contact surfaces (1) of the front disc brake pistons (4 pieces) with brake cleaner.

NOTICE:

Adhesive residue must be completely removed.



b.

Check the cylinder boot (2) for damage and replace if necessary.


c.
C413330

Clean the contact surface (1) of the front disc brake cylinder assembly with brake cleaner and apply a thin coat of brake pad paste.

NOTICE:

Do not mechanically clean the contact surfaces (1) for the front disc brake pads at the front disc brake cylinder assembly to prevent damage to the surface coating.



d.
C413331

Remove the protective film of the adhesive layer (1) at the front disc brake pads.

NOTICE:

The adhesive layer (1) must not be touched.



e.

Insert front disc brake pads into the front disc brake cylinder assembly.

NOTICE:

The adhesive layer must not touch the front disc brake piston.



f.
C413332

Position the No. 1 anti-rattle spring (2).


g.

Drive in torque pins (2) in the direction of the arrow.


h.

Bond the front disc brake pads to the front disc brake piston. For this purpose, fully press the brake pedal and maintain the pressure for 1 minute.


Hide 2.INSTALL PAD WEAR INDICATOR WIRE LH (for LH Side)

a.

Replace the pad wear indicator wire LH.


b.

Insert the pad wear indicator wire LH into the front disc brake pad.

NOTICE:

Ensure pad wear indicator wire LH fits correctly in front disc brake pad.



c.

Attach cable of pad wear indicator wire LH in brackets.


d.

Connect connectors and lock.


e.

Close the connection box.


Hide 3.INSTALL FRONT WHEEL

Hide 4.INSPECT FRONT BRAKE

NOTICE:
·

When exchanging brake pads, reset the CBS display in accordance with factory specification (CBS reset).

·

Carry out test braking while driving at low speed because the effectiveness of the brakes may be reduced during the initial braking operations.

·

Exaggerated emergency and continuous braking operations for faster bedding-in are not permitted.

·

Advise the customer not to perform intentional emergency braking operations for the first 200 km (124 mile) after the brakes have been replaced.



a.

Fully depress brake pedal several times so that brake pads contact brake discs.


b.

Adjust the brake fluid level to the maximum mark.


c.

Perform a functional check on the brake test stand to ensure compliance of the brake system with statutory guidelines.