Home › Brake › PARKING BRAKE › FORCED RELEASE
RM3650E _54 Brake _079884 PARKING BRAKE _0387580 FORCED RELEASE A

PARKING BRAKE  FORCED RELEASE  OPERATION METHOD  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 1. PARKING BRAKE FORCED RELEASE

CAUTION:

Work on a level surface to ensure safety.


NOTICE:
·

When moving the vehicle after releasing the parking brake, install all parts except the connector.

·

A manual emergency release is possible via the spindle drives of the brake calipers. The actuator needs to be disassembled first. Following an emergency release, the electromechanical parking brake must be initialised.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



a.

Park the vehicle on a level surface and check that the shift lever is in P.


b.

Turn the START-STOP button (engine switch) off and check that the wheels are chocked.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



c.

Remove the rear wheel.

Click hereGeneral>MAINTENANCE>TIRE AND WHEEL>REMOVAL

CAUTION:

When using a jack to lift the vehicle, make sure to support the vehicle using safety stands. Do not work on the vehicle with it supported only by a jack.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>VEHICLE LIFT AND SUPPORT LOCATIONS



d.

Remove the parking brake actuator assembly.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>REMOVAL


e.
C415175

Insert a 5 mm socket hexagon wrench into the rear disc brake cylinder assembly.


f.

Turn the 5 mm socket hexagon wrench rotations clockwise to release the parking brake lock.

NOTICE:

When moving the vehicle after releasing the parking brake, install all parts except the connector.



Hide 2. PERFORM INITIALIZATION

a.

Connect the diagnosis system to the vehicle and enter the following menus:

Vehicle management / Service functions / Chassis / Parking brake / Start-up / Commissioning, parking brake