Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM3650E _59 Vehicle Exterior _079886 WIPER / WASHER _0387607 WASHER MOTOR A

WIPER / WASHER  WASHER MOTOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 53875N 2.REMOVE FRONT NO. 2 FENDER LINER RH

HINT:

Use the same procedure as for the LH side.

Click hereSuspension>FRONT SUSPENSION>FRONT LOWER SUSPENSION ARM>REMOVAL


Hide 85301 3.REMOVE WASHER INLET SUB-ASSEMBLY

a.
B539754

Disengage the washer inlet sub-assembly (1) out of the front tabs (2) in the direction of the arrow.


b.
B539790

Remove washer inlet sub-assembly (1) in direction of arrow and feed out from rear tabs (2).


Hide 85330 4.REMOVE WINDSHIELD WASHER JAR ASSEMBLY

a.
B539755

Disengage the clamp (1).


b.

Disengage the washer hose (2) in the marked area (arrows).


c.
B539756

Disconnect the connector (1).


d.
B539757

Remove the screw (1).


e.

Tilt the windshield washer jar assembly (2) from the guides (3) in the direction of arrow.


f.
B539758

Disengage the wire harness in the marked area (arrows).


g.

Disconnect the connectors (1).


h.

Disconnect the washer hose at the snap fastener (2).


i.

Catch the escaping washer fluid.

HINT:

Use a container to collect the washer fluid.



j.

Remove windshield washer jar assembly (3).


Hide 85310 5.REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.
B539760

Remove the windshield washer motor and pump assembly (1) from the windshield washer jar assembly (2).


b.
B539791

Remove strainer with seal (1) in the windshield washer jar assembly (2).