Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR
RM3650E _59 Vehicle Exterior _079886 WIPER / WASHER _0387607 WASHER MOTOR A

WIPER / WASHER  WASHER MOTOR  INSTALLATION  


PROCEDURE

Hide 85310 1.INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

a.

Check the strainer with seal for damage and replace if necessary.


b.

Install strainer with seal in windshield washer jar assembly.


c.

Install windshield washer motor and pump assembly in windshield washer jar assembly.


Hide 85330 2.INSTALL WINDSHIELD WASHER JAR ASSEMBLY

a.
B539758

Connect the washer hose at the snap fastener (2).


b.

Connect connectors (1).


c.

Engage in the line in the marked area (arrows).


d.

Insert washer windshield washer jar assembly (3).


e.
B539792

Install the windshield washer jar assembly (2) into the guides (3) in the direction of the arrow.


f.

Install the screw (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


g.
B539755

Engage in the washer hose (2) in the marked area (arrows).


h.

Engage the clamp (1).


Hide 85301 3.INSTALL WASHER INLET SUB-ASSEMBLY

a.
B539793

Engage the washer inlet sub-assembly (1) into the rear tabs (2) downwards in the direction of the arrow.


b.

Turn the washer inlet sub-assembly (1) in the direction of the arrow towards the initial position.


c.
B539794

Install in the washer inlet sub-assembly (1) to the front tabs (2) the direction of the arrow.


Hide 53875N 4.INSTALL FRONT NO. 2 FENDER LINER RH

HINT:

Use the same procedure as for the LH side.

Click hereSuspension>FRONT SUSPENSION>FRONT LOWER SUSPENSION ARM>INSTALLATION


Hide 5.INSTALL FRONT WHEEL RH