Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM
RM3650E _53 Suspension _079510 FRONT SUSPENSION _0387944 FRONT LOWER SUSPENSION ARM A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL FRONT LOWER SUSPENSION ARM ASSEMBLY

NOTICE:
·

Component damage caused by striking tools.

Brute force can result in component damage.

-

Only use those tools intended for the work.




a.
C413447

Install front lower suspension arm assembly.


b.

Replace the 18 mm bolt and the 18 mm nut.


c.

Using a 18 mm deep socket wrench, tighten the 18 mm nut in the normal position.

Torque:
100 N*m (1020 kgf*cm, 74 ft.*lbf)


d.

Using SST and 18 mm deep socket wrench, tighten the 18 mm nut an additional 90°.

SST
09900-WA010  

HINT:
·
C417459C02
2.99,1.271 3.156,1.188 false 2.906,2.094 2.906,1.76 false 0.875,3 1.208,3 false 0.104,0.125 0.417,0.281 0.313,0.156 10 false *a 0.448,0.125 0.76,0.281 0.313,0.156 10 false *b 2.042,0.125 2.354,0.281 0.313,0.156 10 false *c 3.188,1.073 3.427,1.271 0.24,0.198 10 false *d 2.854,2.146 3.167,2.302 0.313,0.156 10 false *b 1.302,2.927 1.615,3.083 0.313,0.156 10 false *c
*a Example
*b Before Tightening
*c After Tightening
*d Magnetic Portion



·

The magnetic portion is used to secure the gauge to the vehicle.

·

After first adjusting the needle of the gauge to 0°, tighten to the specified angle.

·

Perform the work procedure carefully so that the gauge, etc. does not become tilted.




e.
C413453

Replace nut (1).


f.

Tighten the nut (1), if necessary, counter support the T40 "TORX" socket wrench.

Torque:
175 N*m (1785 kgf*cm, 129 ft.*lbf)


g.

for LH Side:

i.

Clip in the front height control sensor link sub-assembly.



Hide 53876F 2.INSTALL FRONT NO. 2 FENDER LINER

a.
C413452

Insert the front No. 2 fender liner (4).


b.

Tighten the screws (1) and nuts (2).

Torque:
Screw : 2.6 N*m (27 kgf*cm, 23 in.*lbf)
Nut : 2.6 N*m (27 kgf*cm, 23 in.*lbf)


c.

Replace the plastic rivet (3).


d.

Insert the plastic rivet (3).


Hide 3.INSTALL FRONT WHEEL

Hide 4.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT