Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE MASTER CYLINDER
RM3650E _54 Brake _079889 BRAKE SYSTEM (OTHER) _0387639 BRAKE MASTER CYLINDER A

BRAKE SYSTEM (OTHER)  BRAKE MASTER CYLINDER  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

Use only approved brake fluids, see operating fluids.


HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1.INSTALL MASTER CYLINDER BODY

a.
C413612

Replace gasket (1).


b.
C413611

Install master cylinder body (2) in the brake booster.


c.

Replace nuts (1).


d.

Tighten nuts (1).

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


e.
C415177C02
1.563,3.104 1.875,3.26 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Fit brake lines (1) and tighten.

SST
09700-WA070  

Torque:
Specified tightening torque : 17 N*m (173 kgf*cm, 13 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




Hide 2.INSTALL BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY

a.
C413608

Replace the sealing plug (1).


b.
C413609

Install the brake master cylinder reservoir sub-assembly (2).


c.

Tighten down T20 bolt (1).

Torque:
4.0 N*m (41 kgf*cm, 35 in.*lbf)


d.

Connect connectors and lock.


Hide 53681 3.INSTALL UPPER FRONT SUSPENSION CENTER BRACE