Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
84340
1.REMOVE STOP LIGHT SWITCH ASSEMBLY
2.REMOVE MASTER CYLINDER BODY
44764G
3.DISCONNECT CONNECTOR TO BRAKE BOOSTER TUBE
Disconnect the non-return valve (1) from the brake booster.
4.REMOVE BRAKE BOOSTER
Insert the special tool 2 409 646 between the brake pedal support assembly and brake booster.
Apply support (1) of the special tool 2 409 646 on the brake pedal support assembly. If necessary fix the position of the support by rotating the screw on the special tool.
Push special tool 2 409 646 in the direction of the arrow and lever the brake pedal support assembly off the brake booster.
Loosen nuts (1).
Unscrew the brake booster (1) from the bulkhead.