Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1.INSTALL BRAKE BOOSTER
Check the clamp (1) for damage, replace if necessary.
Before installing the holding clip, push the ball socket (1) into the holding clip (2).
Ball socket (1) must engage in a noticeable manner.
Replace the gasket (1) on the brake booster.
Thoroughly clean the sealing surface on the brake booster and on the bulkhead.
Replace grommet (1).
Insert the grommet (1).
Screw in the brake booster in the bulkhead.
Replace nuts.
Tighten nuts.
Press the brake pedal in the direction of arrow and lock it with the brake booster.
The brake pedal must be completely locked with the brake booster.
Screw in the brake booster in the bulkhead.
Replace nuts.
Tighten nuts (1).
Press the brake pedal in the direction of arrow and lock it with the brake booster.
The brake pedal must be completely locked with the brake booster.
44764G
2.CONNECT CONNECTOR TO BRAKE BOOSTER TUBE
Check the grommet on the brake booster and replace, if necessary.
Install the non-return valve in the brake booster.
3.INSTALL MASTER CYLINDER BODY
84340
4.INSTALL STOP LIGHT SWITCH ASSEMBLY
5.BLEED BRAKE LINE