Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY (for Engine Room Side)
RM3650E _57 Power Source / Network _079891 POWER DISTRIBUTION _0387670 INTEGRATION RELAY(for Engine Room Side) A

POWER DISTRIBUTION  INTEGRATION RELAY(for Engine Room Side)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach the cable from the negative (-) battery terminal.




NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



PROCEDURE

Hide 89661 1.REMOVE ECM (for B48)

Hide 89661 2.REMOVE ECM (for B58)

Hide 3.REMOVE NO. 1 INTEGRATION RELAY

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach the cable from the negative (-) battery terminal.




NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




a.
E415904C01
0,0 0,0 false
V113147

Remove in this Direction


Disconnect all the connectors (1).


b.

Detach the claw (2).


c.

Remove the No.1 integration relay (3) as shown in the illustration.