Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › ECM
RM3650E _51 Engine / Hybrid System _080056 B48 ENGINE CONTROL _0388311 ECM A

B48 ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach battery earth lead from battery.




PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 89661 3.REMOVE ECM

NOTICE:
·

Electrostatic discharge.

Damage to or destruction of electrical components.

-

Only touch the housings of electrical components. Do not touch pins or multi-pin connectors directly.

-

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




HINT:
·

Follow instructions for removing and installing control units.

For additional information see:

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

Control unit must be programmed after it is replaced.

For additional information see:

Click hereEngine / Hybrid System>B48 (ENGINE CONTROL)>ECM>PRECAUTION

·

Disconnecting control units may cause fault code entries and functional limitations. Fault code entries must be read out and deleted if necessary.



a.
A442111

Release snap-lock couplings (1).


b.

Feed the engine room ECU cover (2) out toward the top and remove.


c.
A442112

Unlock and disconnect all plug connections (1).


d.
A442113

Unlock the locks (1).


e.

Guide out and remove ECM (2).