Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › SEALING SLEEVE
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387762 SEALING SLEEVE A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  SEALING SLEEVE  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SEALING SLEEVE

a.
C413417

Check the lug (1) for damage and replace the sealing sleeve where necessary.


b.
C413418

Replace the sealing rings (1).


c.
A442406

Carefully position the sealing sleeve (1).

HINT:

Twist the sealing sleeve (1) until the lug has been inserted into the groove of the gear.



d.

Slide in the sealing sleeve (1) in the direction of the arrow up to the limit position.

NOTICE:

The lug on the sealing sleeve (1) must not be damaged.



e.

Remove special tool 0 494 213 (24 2 390).

SST
09300-WA100  


f.
C413407

Push the slide (2) in the direction of the arrow and lock.


g.

Replace the T40 bolt.


h.

Position and tighten the T40 bolt (1).

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)