Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › SERECTOR SHAFT RADIAL SHAFT SEAL
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387752 SERECTOR SHAFT RADIAL SHAFT SEAL A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  SERECTOR SHAFT RADIAL SHAFT SEAL  REMOVAL  


PROCEDURE

Hide 35000 2.SECURE AUTOMATIC TRANSMISSION ASSEMBLY

a.
C411706

Install the automatic transmission assembly to an engine stand.


Hide 4.REMOVE SELECTOR SHAFT RADIAL SHAFT SEAL

CAUTION:
·

Materials harmful to health.

Contact with fluids harmful to health!

-

Note and follow safety information on containers.

-

Conduct all work in appropriate personal protective equipment only.




NOTICE:
·

Damage to the automatic transmission assembly.

Damage to the automatic transmission assembly through unapproved automatic transmission fluid.

-

Use only the approved Automatic Gearbox Oil ATF 3+.

-

After completion of repair work, check automatic transmission fluid level.




a.
C413397

Drive out the clamping sleeve (1) from the selector shaft using a suitable tool.

HINT:

The return spring is under tension.



b.
C413398

Pull the selector shaft (1) from the transmission housing in the direction of the arrow.


c.
C413400

Screw in special tool 0 496 718 (24 5 367) until it has been securely connected to the selector shaft radial shaft seal.

SST
09300-WA130  


d.
C413401

Screw special tool 0 491 783 (24 5 362) onto special tool 0 496 718 (24 5 367) and tighten it.

SST
09300-WA120  
09300-WA130  


e.

Pull the selector shaft radial shaft seal from the transmission housing.