Home › Drivetrain › 8HP51 (AUTOMATIC TRANSMISSION / TRANSAXLE) › SERECTOR SHAFT RADIAL SHAFT SEAL
RM3650E _52 Drivetrain _079902 8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE _0387752 SERECTOR SHAFT RADIAL SHAFT SEAL A

8HP51 AUTOMATIC TRANSMISSION / TRANSAXLE  SERECTOR SHAFT RADIAL SHAFT SEAL  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SELECTOR SHAFT RADIAL SHAFT SEAL

a.
C413402

Oil the sealing lip of the selector shaft radial shaft seal with ATF.


b.

Drive the selector shaft radial shaft seal to the limit position using the special tool 0 494 208 (24 5 366) and a plastic hammer.

SST
09300-WA120  


c.
C413399

Slide the selector shaft (1) into the transmission housing in the direction of arrow.


d.

Replace the clamping sleeve.


e.

Insert narrower end of clamping sleeve into bore hole.


f.

Using a suitable tool, drive in the clamping sleeve until the clamping sleeve is in line with the bore hole.