Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR
RM3650E _58 Vehicle Interior _079905 SEAT BELT _0387785 OCCUPANT DETECTION SENSOR A

SEAT BELT  OCCUPANT DETECTION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753


·

Airbag unit.

Danger! Life-threatening injuries!

-

Before performing any work on the airbag, always disconnect the battery earth lead from the battery.

-

Airbag unit may only be set down with the cushion (airbag itself) facing upwards.

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.



·

Wear protective gloves. Sharp areas on the parts may injure your hands.



NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

HINT:

Use the same procedure as for the driver side.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REMOVAL


Hide 2.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

HINT:

Use the same procedure as for the driver side.

Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>REMOVAL


Hide 3.REMOVE BELT WARNING OCCUPANT DETECTION SENSOR

a.
B541872

Remove the tie band (1).


b.
B542572C01
0,0 0,0 false
V113147

Remove in this Direction


Detach the claws (6) to remove the connectors in order from (1) to (4) from the connector housing (5) in the direction of the arrow.


c.
B541427

Detach the claws (2) and clamp (3).


d.

Detach the cable (4) from the holder (5).


e.

Remove the belt warning occupant detection sensor (1) from the front seat assembly carefully.