Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)
RM3650E _58 Vehicle Interior _080097 SEAT _0388585 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the driver side and front passenger side.

·

The procedure listed below is for the driver side.



PROCEDURE

Hide 73220 1.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

Hide 2.REMOVE FRONT SEAT ASSEMBLY

CAUTION:
·
B475753

Airbag unit.

Danger! Life-threatening injuries!

-

Before performing any work on the airbag, always disconnect the battery earth lead from the battery.

-

Airbag unit may only be set down with the cushion (airbag itself) facing upwards.

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.




a.
B539392

Move the front seat assembly to the rearmost position.


b.

Loosen the T50 bolts (1).


c.
B539393

Move the front seat assembly to the foremost position.


d.

Set the seat cushion height of the front seat assembly to the uppermost position.


e.

Loosen the T50 bolts (1).


f.

Set the seat cushion height of the front seat assembly to the lowermost position.


g.
B541870C01
0,0 0,0 false
V100136

Move in this Direction


Move the steering column (1) completely forwards and upwards.


h.

Move the rear seatback (3) as shown in the illustration.


i.

Disconnect the cable from the negative (-) battery terminal.


CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




j.

Cover the front door scuff plate with protective covers.


k.
B539394

Tilt the front seat assembly backwards to disconnect the connector (1).


l.

Remove the front seat assembly with another person.

NOTICE:
·

Heavy component.

Heavy components can lead to injury or damage.

-

Remove and install heavy components with the aid of another person/other persons.


·

Protect the front seat leg.

·

Be careful not to damage the front seat assembly, body exterior or body interior.