Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387802 SPIRAL CABLE A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753

Airbag unit.

Danger! Life-threatening injuries!

-

Before performing any work on the airbag, always disconnect the battery earth lead from the battery.

-
B528833C05
0,0 0,0 false
V100155

Cushion (Airbag Itself)


Airbag unit may only be set down with the cushion (airbag itself) facing upwards.

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.



·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.


·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach the cable from the negative (-) battery terminal.




NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



PROCEDURE

Hide 84310 1.REMOVE TURN SIGNAL SWITCH ASSEMBLY

Hide 84306 2.REMOVE SPIRAL CABLE SUB-ASSEMBLY

a.
B538708

Detach both claws (1) on the turn signal switch assembly (2).


b.
B538709

Detach the central and left claws (1) on the turn signal switch assembly (2).


c.

Remove the spiral cable sub-assembly (3) from the turn signal switch assembly (2).