Airbag unit.
Danger! Life-threatening injuries!
All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
Replace any damaged part or ones that have been dropped.
Before performing any work on the airbag, always disconnect the battery earth lead from the battery.
Airbag unit may only be set down with the cushion (airbag itself) facing upwards.
For additional information see: Safety regulations on handling components with gas generators.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for B48:
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
for B58:
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
45100
2.REMOVE STEERING WHEEL ASSEMBLY
45286B
3.REMOVE UPPER STEERING COLUMN COVER
Using a moulding remover A, disengage the clips (2) to disconnect the steering column cover (1).
Press in the rubber plug (1) with the T15 "TORX" screwdriver to the inside and into the lower steering column cover.
The rubber plugs are reusable. Process to reuse the rubber plug: remove the lower steering column cover and remove the rubber plug.
Perform the operations on the left and right side.
Press the T15 "TORX" screwdriver (1) in the direction of the arrow and lever the tab (2) to the inside.
Perform the operations on the left and right side.
Press the upper steering column cover (3) to the top at the same time.
Perform the operations on the left and right side.
Remove the upper steering column cover (1) out to the top as shown in the illustration.
45287
4.REMOVE LOWER STEERING COLUMN COVER
Push the claw (1) to the outside in the direction of the arrow and unclip the lower steering column cover (2) in the direction of the arrow to the bottom.
Perform the operations on the left and right side.
Tilt the lower steering column cover (1) down.
Disconnect the connector (2).
Disengage the guide (3) to remove the lower steering column cover (1).
Remove rubber plugs (1) from the lower steering column cover.
84310
5.REMOVE TURN SIGNAL SWITCH ASSEMBLY
Using a deep socket wrench 7 mm, remove the screws (1).
Thread out the turn signal switch assembly (2).
Disconnect the connectors (1) to remove the turn signal switch assembly (2).
84306
6.REMOVE SPIRAL CABLE SUB-ASSEMBLY