Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
73990
1.INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Check that the START-STOP button (engine switch) off.
Pressing and holding the AUDIO button changes the power source mode to IG OFF.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Replace the nuts (2).
Install the lower No. 2 instrument panel airbag assembly (3) and tighten the nuts (2).
Connect the connectors (1) and lock.
55606
2.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for B48:
for B58: