Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387811 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.INSTALL SIDE AIRBAG PRESSURE SENSOR

a.

Check that the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B538721

Turn the side airbag pressure sensor (3) in the direction of the arrow until the claw (2) attach.


d.

Connect connectors (1) and lock.


Hide 67602 2.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 81230 3.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL