Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › POP UP HOOD SENSOR
RM3650E _58 Vehicle Interior _079907 SUPPLEMENTAL RESTRAINT SYSTEMS _0387814 POP UP HOOD SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  POP UP HOOD SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B475753

Pyrotechnic components.

Danger! Life-threatening injuries!

-

All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.

-

Replace any damaged part or ones that have been dropped.



·

Working on 12 V vehicle electrical system.

Risk of short circuits! Risk of fire!

-

Detach the cable from the negative (-) battery terminal.



·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:
·

Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal to prevent damage to the electrical system or components.

·

When disconnecting the cable, turn the START-STOP button (engine switch) and headlight switch off and loosen the cable nut completely. Perform these operations without twisting or prying on the cable. Then disconnect the cable.

·

Clock settings, radio settings, audio system memory, DTCs and other data will be cleared when the cable is disconnected from the negative (-) battery terminal. Write down any necessary data before disconnecting the cable.



PROCEDURE

Hide 52119A 1.REMOVE FRONT BUMPER COVER

Hide 2.REMOVE PEDESTRIAN DETECTION CHAMBER ASSEMBLY

a.

Check that the START-STOP button (engine switch) off.

HINT:
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.



b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.




c.
B538715

Unlock and disconnect plug connections (1).


d.

Detach the claws (3) to remove the front bumper energy absorber with pedestrian detection chamber assembly (2).


e.
B538716

Remove the pedestrian detection chamber assembly (1) from the front bumper energy absorber (2).