1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for B48:
Click hereGeneral>MAINTENANCE>B48 BATTERY>REMOVAL
for B58:
Click hereGeneral>MAINTENANCE>B58 BATTERY>REMOVAL
53879
2.REMOVE FRONT FENDER LINER LH
Remove the 13 screws, clip and front fender liner LH (1).
53878
3.REMOVE FRONT FENDER LINER RH
Use the same procedure as for the LH side.
53381
4.REMOVE HOOD TO RADIATOR SUPPORT SEAL
Remove the hood to radiator support seal (1).
53826A
5.REMOVE FRONT FENDER UPPER PROTECTOR LH
Remove the clips (1) and clips (2).
Remove the front fender upper protector LH (3).
53825A
6.REMOVE FRONT FENDER UPPER PROTECTOR RH
Use the same procedure as for the LH side.
7.REMOVE FRONT BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape as shown in the illustration.
Remove the T20 screws (1).
Perform the operations on the left and right side.
Disengage front bumper assembly from the clamp (2).
Perform the operations on the left and right side.
Disconnect the connector (1).
Perform the operations on the left and right side.
Disengage the clamp (2).
Perform the operations on the left and right side.
Remove the screws (arrows) on the front bumper assembly.
Remove the bolts (1).
Disengage the clamps (1) and guides (2) to separate the front bumper assembly.
Disengage the fasteners to remove the front bumper assembly (1).