Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH
RM3650E _59 Vehicle Exterior _079908 LIGHTING (EXT) _0387824 HEADLIGHT DIMMER SWITCH A

LIGHTING (EXT)  HEADLIGHT DIMMER SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE SUB-ASSEMBLY

Hide 84310 2.INSTALL TURN SIGNAL SWITCH ASSEMBLY

a.
B536821

Connect the connectors (1) with the turn signal switch assembly (2).


b.
B536820

Using a deep socket wrench 7 mm, install the turn signal switch assembly (2) with the screws (1)

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 45287 3.INSTALL LOWER STEERING COLUMN COVER

a.
B536822

Connect the connector (1).


b.

Engage the guide (2).


c.
B536823

Align the lower steering column cover (1) at the claw (2) to the steering column.

HINT:

Perform the operations on the left and right side.



d.

Press the lower steering column cover (1) upwards in direction of arrow until the claw (2) engage.

HINT:

Perform the operations on the left and right side.



Hide 45286B 4.INSTALL UPPER STEERING COLUMN COVER

a.
B536824

Guide in the upper steering column cover (1).


b.

Press the upper steering column cover (1) down and engage.

NOTICE:

The upper steering column cover (1) must engage audibly and perceptibly.



c.
C413487

Seal the bore hole using a rubber plug (1).

HINT:

Perform the operations on the left and right side.



d.
B536826

Engage the clips to connect the steering column cover (1).


Hide 45100 5.INSTALL STEERING WHEEL ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL