Home › Suspension › REAR SUSPENSION › REAR STRUT BAR
RM3650E _53 Suspension _079981 REAR SUSPENSION _0387950 REAR STRUT BAR A

REAR SUSPENSION  REAR STRUT BAR  INSTALLATION  


PROCEDURE

Hide 64288D 1.INSTALL TRANSVERSE PIPE TRIM

a.

Install the transverse pipe trim to the tonneau cover holder.

HINT:

Use the same procedure for both sides.



Hide 64277L 2.INSTALL TRANSVERSE PIPE

a.
A442514

Thread the transverse pipe (2) from the top under the trim panels of the deck side trim cover and position.


b.

Tighten down T50 bolts (1).

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


Hide 62609 3.INSTALL SEAT BELT HOLE COVER SUB-ASSEMBLY LH

Hide 62608 4.INSTALL SEAT BELT HOLE COVER SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 64288D 5.INSTALL TRANSVERSE PIPE TRIM

a.
A442511

Move the transverse pipe trim (1) in direction of arrow on the transverse pipe (3) and clip in with the claws (2).

HINT:

Use the same procedure for both sides.



Hide 62480A 6.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH

Hide 62470A 7.INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 64330D 8.INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY