Home › Suspension › REAR SUSPENSION › REAR COIL SPRING
RM3650E _53 Suspension _079981 REAR SUSPENSION _0387952 REAR COIL SPRING A

REAR SUSPENSION  REAR COIL SPRING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL REAR COIL SPRING

NOTICE:
·

Do not operate special tool with an impact wrench.

·

Incorrect assembly is possible.

Ensure correct installation position.



a.
C417136

Screw in rear coil spring (1) into the special tool 0 494 933 (33 5 010) and tighten.

SST
09700-WA160  

NOTICE:
·

Make sure rear coil spring (1) is in correct installation position.

·
C417131

Make sure rear coil spring (1) is correctly positioned in spring cups.




b.
C417137

Check rear lower coil spring insulator (1) for damage, replace if necessary.


c.

Check rear lower coil spring insulator (1) for correct position on the rear No. 2 suspension arm assembly, correct the position if necessary.

HINT:

The plastic tab (2) must be positioned in the bore hole.



d.
C417138

Install rear coil spring (1) from the top and position it.


e.
C417139

Move the rear coil spring (1) of the rear lower coil spring insulator (2) so that they are positively locked to the system.


f.
C417140

Position the rear upper coil spring insulator such that the end of the rear coil spring (1) moves to the system at the base (2).


g.
C417133

Release the tension on the rear coil spring using the special tools 0 494 997 (33 5 016) and 0 494 934 (33 5 020).

SST
09700-WA160  
09700-WA180  

NOTICE:

Note the installation position of the rear coil spring while releasing the tension.


HINT:

Counter-hold the spindle of the spring tensioner using special tool 0 494 998 (33 5 017).



h.

Remove special tools.


i.

Fasten the rear skid control sensor wire on the holder on the rear shock absorber assembly.


j.

w/ AVS:

i.
C413663

Connect connectors (1) and lock.


ii.

Attach the lines (2) to the holder.



Hide 48738 2.INSTALL REAR SUSPENSION ARM COVER

Hide 3.INSTALL REAR WHEEL