Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR
RM3650E _53 Suspension _079981 REAR SUSPENSION _0387958 REAR STABILIZER BAR A

REAR SUSPENSION  REAR STABILIZER BAR  INSTALLATION  


PROCEDURE

Hide 48812 1.INSTALL REAR STABILIZER BAR

CAUTION:
·

The rear suspension member sub-assembly is a very heavy component. Make sure that it is supported securely.

·

If the rear suspension member sub-assembly is not securely supported, it may drop, resulting in serious injury.



NOTICE:

Use attachments and wooden blocks to keep the rear suspension member sub-assembly level.


a.

Coat the outer sides of the rubber mounts with assembly aid.


b.
C413596

Install the rear stabilizer bar (3).


c.

Position both rear No. 1 stabilizer bar brackets (2).


d.

Replace E12 bolts (1).


e.

Tighten the E12 bolts (1).

Torque:
21.4 N*m (218 kgf*cm, 16 ft.*lbf)


Hide 51206A 2.INSTALL REAR SUSPENSION MEMBER SUB-ASSEMBLY

Hide 48840A 3.INSTALL REAR STABILIZER LINK ASSEMBLY LH

a.
C413598E01
1.531,1.708 1.938,1.167 true

Position rear stabilizer link assembly LH (2).


b.

Replace 16 mm nuts (1).


c.

Tighten the 16 mm nuts (1), if necessary, counter support the T30 "TORX" socket wrench.

Torque:
56 N*m (571 kgf*cm, 41 ft.*lbf)


Hide 48830D 4.INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 5.INSTALL REAR WHEEL